Dellorto PHBG 19.5mm carburetor replica Puch Maxi set

Dellorto PHBG 19.5mm carburetor replica set with manifold and air filter

Including:

• Carburetor model PHBG 19.5mm
• Manifold Dellorto (Steel or aluminium version is supplied)
• Suction rubber
• Sieve airfilter
• Clamp
• Centre-to-centre distance between mounting holes: 38mm
• For Puch E50 engine

Note:

• Do not over-tighten the carburettor clamp!
  
• The float bowl is fixed with 4 bolts, 3 long ones and 1 short one. Always make sure you replace the short bolt on the corner of the air set screw! If you screw a longer bolt in here, it will hit the air set screw and block it.
• The jet that is mounted in the carburettor / set is blank and different for each batch. (The manufacturer does this because they cannot know on which engine / setup this carburettor will be mounted).
• It is therefore highly advisable to order a jet-set so that you can always achieve maximum adjustment.
• Chances are that the carburettor and the filter will not fit directly between the cylinder and the frame. By filing the little holes in the manifold, it can be modified in such a way that the carburettor and filter will fit, even with frame brackets attached.