Exhaust Puch Maxi / E50 28mm Homoet P8 PSR raw (74cc)

Homoet P8 PSR Exhaust!
Only at our shop! P8 Homoet racing exhaust with separate silencer!

• Raw, rough, no paint whatsoever, simply oil it and drive!
• For Gilardoni 74cc, Metrakit 74cc, Parmakit 74cc. (cylinders with angled exhaust port)

Measurements exhaust (picture 7)

• A: 930mm length
• B: 700mm length 
• C: 860mm length 
• D: 28mm outer diameter
• E: 25mm inner diameter

This Homoet exhaust is now fitted with a slotted mounting lip, this makes fitting easier!

Watch out for fake Homoet exhausts, these are the originals! There are fakes of very poor quality in circulation!

Tips:

• Use our long brass M6 nuts in combination with hardened studs (see related products). This so you can easily and fully tighten the exhaust flange. Brass is also softer than steel, so it will not seize.
• Always use a new exhaust gasket when fitting an exhaust

When using all exhausts, black painted, chrome and blanc exhausts, heat build-up at the exhaust manifold can cause the following:

• At black outlets the paint can dissolve a little.
• Chrome and blanc exhaust manifolds may discolour

If the nozzle is too small or if the ignition is set incorrectly, the exhaust port becomes very hot and discoloring and dissolve of the paint on the exhaust manifold will occur faster than a perfectly adjusted engine. We give no guarantee on discoloration or solving of the paint on the exhaust manifold!