Cylinder 50cc OM Athena original 25 km/h 1.2 hp Puch Maxi, X30 and other models
Read more about the European VAT rules
- A few left in stock
- Brand: Athena
- Model: 10009
This cylinder of the Italian brand Athena is the result of years of development and expertise.
Athena has based this cylinder on the standard Puch moped cylinder and has finished it to perfection. This results in a reliable cylinder of the highest quality.
The set comes standard with piston, piston pin and piston rings.
- 50cc Aluminium cylinder, nicasilwall.
- Original 25 km/h model with inlet restriction.
- Supplied without gasket set!
- With piston (piston pin 12mm)
- Cylindersleeve outer diameter: 48mm
We always advise to check and clean the cylinder before installation and to finish the ports in the cylinder with a 1000 grit sandpaper. This way the edges are no longer too sharp because of the Nicasil coating, this will considerably extend the life of the cylinder / piston.
The cylinder is compatible for use on a Puch Maxi S / Maxi N / Maxi K / Maxi P / X20 / X30, Korado, Manet and KTM hobby with E50 / Z50 / ZA50 engine. Just note that you may have to make some modifications. Want advice on whether this cylinder fits your moped? Please contact us.
|Cylinder / head|
|Cylinder model||Old model|
|Puch Maxi cylinder and head difference old and new model + video|
|Puch Maxi cylinder mounting | With these tips you can not go wrong!|
|Puch cylinder installation? You should definitely not forget that!|