Ignition inner rotor Selettra KZ10 SML 12V Puch / universal

Selettra KZ10 SML Internal Rotor Ignition with lighting coil

New Selettra ignition type, equipped with a 12V lighting coil. Absolute top quality from Selettra! Compared to conventional ignition systems, the internal rotor ignition is much more agile due to the low rotor-flywheel mass (200 g), allowing the engine to rev up faster. Additionally, the ignition timing noticeably affects power delivery

• It is possible to charge a battery while simultaneously powering the lighting system
• The ignition is suitable for both left- and right-rotating engines
• The ignition and lighting sections are separated on the stator, reducing the risk of overheating
• The ignition is supplied including a voltage regulator
• Suitable for setups up to 14,000 rpm
• Stator with 3,200 windings
• Stator diameter: 90 mm
• For Puch, Tomos, Kreidler, Hercules, Minarelli, Sachs 3-speed

Note: Use a high flywheel cover with this ignition on Puch E50 / Z50 / ZA50 models

Technical Specifications:

• Usable power: up to 7 A
• Lighting output: up to 65 W
• Rotor ratio: 1:5
• Maximum operating temperature: 80 °C
• Regulated output voltage: 14.5 ± 0.5 V
• Stator weight: 480 g
• Rotor weight: 250 g
• Regulator weight: 135 g

Universally applicable to various models:

• Puch Maxi / X30 / Macho
• Puch MV / VS / MS / DS / Monza
• Tomos A3 / A35 / A52 / A55
• Kreidler Florett / RS50 / RMS50
• Hercules / Sachs
• Zündapp KS50

Attention: An inner rotor ignition can generate more heat during operation than an original contact points or CDI ignition. We therefore recommend providing the ignition cover with sufficient ventilation openings to ensure that heat can dissipate properly. Insufficient ventilation may lead to overheating, which can negatively affect the performance and service life of the ignition or cause damage. Always make sure that the ignition has sufficient clearance and is installed correctly.