Flywheel cover pull starter Puch Maxi E50 Bosch / HPI / MVT / various ignition models Fast Arrow chrome

Pull starter for Puch Maxi E50 engine Fast Arrow

• Ready-to-install pull starter for clockwise rotating Puch E50 engines on your Puch Maxi S / N or Puch Supermaxi LG1 moped.
  
• Good quality, can be used without problems with all cylinders from 50cc till 70cc!
• The pull starter is supplied with 3 different starter pinions and can therefore be used for multiple ignition types
• The pull starter is delivered including a Puch sticker

Note: The pull starter is supplied with a plastic ring, which must be installed under the cover on the engine!

Suitable for the following models:

• Bosch / Ducati / Iskra ignition
• HPI 068 / 210
• MVT Analog / MVT Digital Race

Mounting:

• Starter pinion: clean the flywheel, remove the original flywheel nut. Then screw the carriage for the pull starter onto the crankshaft. Tip: mount the carrier with loctite.
  
• Pull starter: Place the starter housing in the correct position and tap lightly with a plastic hammer until the pull starter fits perfectly. It can then be screwed into place. 

Application:

• Before starting, pull the cable slowly a few times so that the engine spins empty (must be done before each start attempt).
  
• Pull out the pull-start handle until it is fully engaged and you encounter resistance. Then pull through in one go.
• Tip: Wear gloves! Hold the handle firmly.

Tipp:

• The pedal system can no longer be operated because the pedal arms would touch the housing of the pullstarter. Therefore, footrests, a longer pedal axle or a pedal axle extension must be fitted.