Exhaust Puch Maxi / E50 28mm RS cigar resonance "Super Reso" black

RS cigar Exhaust Puch Maxi / E50 28mm cigar resonance "Super Reso" black edition

• RS Resonance cigar chrome - inconspicuous and powerful. Faster than the normal RS cigar!
• Optically an ordinary cigar exhaust, but inside a counter cone is worked in. This turns the supposedly original muffler into a resonance exhaust.
• Exhaust manifold included!
• With heat-resistant coating
  
• Note: be careful when mounting, the black coating may be damaged
• With manifold for Puch Maxi S / N / K / E50 / X30
• For all who want to combine original optics with tuning.
• The special exhaust has a pleasant volume even at higher speeds
• Note: always check that the nut on the rear of the damper is tight before mounting!
  

Measurements exhaust (picture 5)

• A: 1030mm lengte
• B: 300mm lengte
• C: 730mm length 
• D: 25mm innerdiameter
• E: 28mm outer diameter

Caution:

This exhaust can be used with most pedals, due to the moped falling over, pedals may be bent and hit the exhaust also use of different suspension brackets or bent suspension brackets may cause the pedals to hit the exhaust anyway.

Tips:

Use our long brass M6 nuts in combination with hardened studs (see related products). This so you can fully tighten the exhaust flange and to make exhaust assembly easier. In addition, brass is softer than steel, so will not seize.

• Always use a new exhaust gasket when fitting an exhaust
• When using all exhausts, black, chrome and clear exhausts, the following may occur due to heat build-up at the exhaust bend:
• On black exhausts, the paint may dissolve slightly
• Chrome and clear exhausts can discolour

With a too small nozzle or an incorrectly tuned ignition, the exhaust port becomes very hot and will occur more quickly than a perfectly tuned engine. We do not guarantee discolouration or dissolution of the paint on the exhaust bend!