Cylinder 50cc NM DMP alu 6-port set Bing 15mm Puch Maxi X30

Special offer: DMP Complete cylinder kit 50cc / 38mm

• DMP 50cc cylinder
• 50cc HD head
• Piston (piston pin 12mm) complete
• Gasket set
• 15mm Bing replica-carburetor (very high quality!) 3mm jets!
• 15mm manifold
• Chrome powerfilter

Cylinder information

• Piston (piston pin 12mm) included, 6-port version
• Very good allround cylinder
• Cylindersleeve outer diameter: 48mm 

Bing 15mm carburetor replica

• Connection diameter of the manifold 20mm
• Connection diameter of the air filter 20mm
• Nozzles/jets suitable for this carburettor are Bing 3.5mm jets/nozzles
• Carburettors are delivered with a blank nozzle/jet, of which the size is unknown.
• Carburettors should always be cleaned before installation.

Before mounting / note:

• We always advise to check and clean the cylinder before installation and to finish the ports in the cylinder with a 1000 grit sandpaper. This way the edges are no longer too sharp because of the Nicasil coating, this will considerably extend the life of the cylinder / piston.
• Do not overtighten your carburetor to your manifold, as this may cause the clamp to break. No warranty when you have overtightening the clamp!
• So the nozzle should be changed at all times before fitting the carburettor with a nozzle that suits the set-up. So the blank nozzle cannot be used.
• The jet that is mounted in the carburettor / set is blank and different for each batch. (The manufacturer does this because they cannot know on which engine / setup this carburettor will be mounted). It is therefore highly advisable to order a jet-set so that you can always achieve maximum adjustment.

Models

• The cylinder is compatible for use on a Puch Maxi S / Maxi N / Maxi K / Maxi P / X20 / X30, Korado, Manet and KTM hobby with E50 / Z50 / ZA50 engine. Just note that you may have to make some modifications. Want advice on whether this cylinder fits your moped? Please contact us.