Cylinder 65cc Metrakit Puch Maxi, X30 and other models

Metrakit 65cc cylinder (43.5mm).

• Finally back again!! This time in aluminium/Nicasil!
• Now with a improved piston! piston pin 12mm
• For the perfect timing use 2 base gaskets! (not included)
• Without gasket set (see related products)
  
• Very strong cylinder, with a lot of torque.
• A 20mm carburettor is possible due the large inlet port.
• Delivered as in pictures. Cilinders are not painted, rough machine finish on the outside.
• Cylindersleeve outer diameter: 48mm 
• The cylinder shape does not 100% match an old or new model. A new model cylinder head matches best.
  

Before mounting

• We always advise to check and clean the cylinder before installation and to finish the ports in the cylinder with a 1000 grit sandpaper. This way the edges are no longer too sharp because of the Nicasil coating, this will considerably extend the life of the cylinder / piston.

Models

• The cylinder is compatible for use on a Puch Maxi S / Maxi N / Maxi K / Maxi P / X20 / X30, Korado, Manet and KTM hobby with E50 / Z50 / ZA50 engine. Just note that you may have to make some modifications. Want advice on whether this cylinder fits your moped? Please contact us.

Measurements cylinder

• A: 7mm
• B: 44mm
• C: M6
• D: 67mm
• E: 28mm
• F: 42mm
• G: M6
• H: 38mm
• I: 19imm
• J: 19mm
• K: 19mm

Measurements piston

• A: 3mm
• B: 22mm
• C: 24mm
• D: 12mm