Cylinder 65cc NM Polini reed valve Puch Maxi, X30, others

Polini 65cc (43.5mm) reed valve cylinder Aluminium, nicasil wall.

• Piston (piston pin 12mm)
• Reed valve
• Manifold (20mm outer diameter)
• Gaskets set included.
• One of the fastest cylinders for Puch Maxi
• Cylindersleeve outer diameter: 48mm
• 144.0150 
  

Attention! Very sensable cylinder!

Fit the cylinder with 8Nm, fit the gaskets in the intake pipe with liquid gasket and do not tighten too tightly. Then you will have a cylinder that lasts a long time and is very fast.

Before mounting

We always advise to check and clean the cylinder before installation and to finish the ports in the cylinder with a 1000 grit sandpaper. This way the edges are no longer too sharp because of the Nicasil coating, this will considerably extend the life of the cylinder / piston.

Models

The cylinder is compatible for use on a Puch Maxi S / Maxi N / Maxi K / Maxi P / X20 / X30, Korado, Manet and KTM hobby with E50 / Z50 / ZA50 engine. Just note that you may have to make some modifications. Want advice on whether this cylinder fits your moped? Please contact us.

Measurements cylinder

• A: 7mm
• B: 44mm
• C: M6
• D: 68mm
• E: 22mm
• F: 42mm
• G: M4
• H: 36mm
• I: 35mm
• J: 38mm
• K: -

Measurements piston

• A: 4mm
• B: 23mm
• C: 24mm
• D: 12mm