DMP reed
valve cylinder 70cc (45mm) Aluminium
- Piston (piston pin 12mm), reed
valve and manifold included.
For best result, cut hole in de piston or shorten inletside of piston
Piston has a 38mm dome, best cilinderhead is a 38mm version.
- Without gaskets!
(Listed below at the related products)
- Connection diameter manifold
26mm. Fits all Dellorto PHBG and Replica PHBG (remove plastic bush)
- Replace the reed valves for carbon /
carbonit versions.
- Aluminium cilinder with Nicasil
coating.
- With seperated (butterfly) exhaust port
- Cylindersleeve outer diameter: 48mm
We always
advise to check and clean the cylinder before installation and to finish the
ports in the cylinder with a 1000 grit sandpaper. This way the edges are no
longer too sharp because of the Nicasil coating, this will considerably extend
the life of the cylinder / piston.
Measurements cylinder
- A: 7mm
- B: 44mm
- C: M6
- D: 69mm
- E: 26mm
- F: 42mm
- G: M6
- H: 60mm
- I: 44mm
- J: 40mm
- K: -
Measurements piston
- A: 5mm
- B: 22mm
- C: 27mm
- D: 12mm